-
Variable Length Range: 90" - 151" and 15" Riser
-
Specifications
- Variable speed models are available in variable lengths only.
- Check valve: 2¾" diameter fluorocarbon seal constructed with cast aluminum body and steel backing washer.
- Pressure relief valve: available in four pressure relief settings, integral to check valve. Standard model relieves at 40 psi and resets above 35 psi.
- Syphon: venturi-type syphon primer supplied with every submersible. Syphon check valve and secondary syphon sold separately.
- Air eliminator: every submersible includes a tank return path with one-way check valve to provide active air elimination.
- Electrical disconnect: electrical yoke for positive contractor disconnect during service.
Pump Motor
- 2 Hp, variable speed, two-stage centrifugal type pump motor with integral, automatic, thermal overload protection.
- Max. flow: VS2 = 110 gpm, VS4 = 140 gpm.
- Max. pressure: selectable operating pressure on MagVFC between 24 psi and 42 psi deadhead.
- Available with MagShell™ which results in 45% increased flow area around motor.
Approvals
- cULus listed.
- Consult factory for applicable approvals.
Power Requirements
- Variable speed pumps can only be controlled by a MagVFC variable frequency controller:
- VS2 models can operate with single- or three-phase incoming power supply to the MagVFC.
- VS4 models require three-phase incoming power supply to the MagVFC for proper operation.
- Incoming power supply to the MagVFC can be 200-250 VAC, 50 or 60 Hz.
- MagVFC outputs a three-phase, variable frequency signal, valid for FE Petro variable speed pumps only.
- VS2 max. motor draw: 9 Amps.
- MagVFC max. line draw: 20 Amps.
Liquid Compatibility
- Max. liquid viscosity: 70 SSU at 60 °F (15 °C).
- STP variable speed models are UL and cUL listed for fuel mixtures containing up to 10% ethanol, and 20% MTBE, 20% ETBE or 17% TAME with gasoline.
- IST variable speed models are UL and cUL listed for fuel mixtures containing diesel fuel with up to 20% biodiesel, 100% biodiesel, up to 85% ethanol with gasoline, and 20% MTBE, 20% ETBE or 17% TAME with gasoline.
- All variable speed (non-AG) models can also be used with diesel fuels, fuel oils, kerosene, Avgas and jet fuels in a non-gelled pourable state.
- All wetted elastomers are made of a high grade, fluorocarbon compound.